You're viewing a previously published revision of this guide. View latest revision

Dec 15, 2021 - 04:12:53

Feb 04, 2022 - 12:02:47 Jan 22, 2022 - 07:01:46 Dec 28, 2021 - 11:12:56 Dec 25, 2021 - 06:12:08 Dec 25, 2021 - 04:12:28 Dec 20, 2021 - 09:12:20 Dec 20, 2021 - 08:12:12 Dec 16, 2021 - 09:12:25 Dec 15, 2021 - 07:12:05 Dec 15, 2021 - 07:12:59 Dec 15, 2021 - 07:12:04 Dec 15, 2021 - 07:12:07 Dec 15, 2021 - 07:12:07 Dec 15, 2021 - 07:12:15 Dec 15, 2021 - 06:12:44 Dec 15, 2021 - 05:12:11 Dec 15, 2021 - 05:12:18 Dec 15, 2021 - 05:12:39 Dec 15, 2021 - 05:12:20 Dec 15, 2021 - 05:12:42 Dec 15, 2021 - 04:12:53 Dec 15, 2021 - 04:12:46 Dec 15, 2021 - 04:12:59 Dec 15, 2021 - 03:12:02 Dec 15, 2021 - 03:12:55 Dec 15, 2021 - 03:12:51 Dec 15, 2021 - 03:12:48

Newer

03. Y-Axis Motor Assembly

Written By: Simon Davie (and one other contributor)

Comments: 0
Favorites: 0
Completions: 18

Steps

Step 1 Prepare the Y-Axis Motor Parts

1x 40mm NEMA17 Stepper Motor
y_motor_cage printed part
4x M6x12 Cap Head Screw
4x M3x8 Cap Head Screw
1x 20 Tooth 2GT Timing Pulley for 9mm Belt
4x 3030 Square T-Nut - M6
1x M8x30 Cap Head Screw

Step 2 Assemble the Y-axis motor mount - Part 1

y_motor_cage printed part
M6x12 Cap Head Screw
3030 Square T-Nut - M6
Loosely thread the 3030 T-Nuts onto the M6x12 screws. Do not tighten them at this point.
40mm NEMA17 Stepper Motor
Fasten the M3x8 screws to secure the stepper motor to the mount
Take care not to over tighten the M3x8 screws as you can damage the printed part