Skip to main content

Changes to 01. V-Motion Lite - Standard Assembly Introduction

Edit by Rat Rig

Edit approved by Rat Rig

Before
After
Unchanged
Category
V-Motion Lite
Type
how-to
Title
V-Motion Lite - Standard Assembly
Introduction
The ***V-Motion Lite*** can be assembled on any ***V-Slider*** or ***V-Slider Mini***. There are two alternative ways of assembling:
* ***Standard assembly:*** motor shaft points down. You should use this assembly if the head you’re mounting on your slider’s carriage has a diameter of less than 10 cm.
* ***Reversed assembly:*** motor shaft points up. You should use this assembly if the head you are mounting on your slider’s carriage has a diameter of 10 cm or more, otherwise you might not be able to mount the head in place as the motor will be in the way. This assembly involves additional steps and is not compatible with the V-Slider Leg Kit(tripod use only).
Time Required Min
No estimate
Time Required Max
No estimate
Imageid
Before
After
Difficulty
Moderate
Author
Public
No

Parts

  • V-Motion Motor x1 added.
  • Belt x1 added.
  • 3mm Hex Key x1 added.
  • AA Battery Pack (for 8x AA batteries) x1 added.
  • V-Motion Controller x1 added.
  • Knob x2 added.
  • T-Nut x2 added.

Flags

  • In Progress added.

Steps

Step #: 1
Before
After