Changes to Step #12
Edit by Simon Davie —
Edit approved by Simon Davie
- Before
- After
- Unchanged
Step Lines
| [title] Remove the front motor mounts | |
| [* 2] Remove the four marked M6x20 screws | |
| [* 3] Remove the front left z-axis motor mount | |
| [* 4] Retrieve the four 3030 drop-in t-nuts from the 3030 extrusion | |
| [* 5] Repeat the above three steps for the motor mount on the front right side | |
| + | [* 10] Set both assemblies aside until ***Step 25*** |