Changes to Step #4
Edit by Simon Davie —
Edit approved by Simon Davie
- Before
- After
- Unchanged
Step Lines
| [title] Assemble the frame magnet mounts (x10) | |
| [* 2] panel_magnet_mount printed part | |
| [* 3] Neodymium Disc Magnet - 10x4mm | |
| + | [* 10] The magnets are designed to be a tight fit into the printed part. If they are loose, or you wish to secure them further, place a few drops of cyanoacrylate glue into the printed part before adding the magnet |
| [* 4] M6x12 Cap Head Screw | |
| [* 5] 3030 Drop-in T-Nut - M6 | |
| [* 10] Loosely thread the 3030 T-Nuts onto the M6x12 screws. Do not tighten them at this point. | |
| [* 10] Set these assemblies aside until ***Step !!*** |