Changes to Step #5
Edit by Simon Davie —
Edit approved by Simon Davie
- Before
- After
- Unchanged
Step Lines
| + | [title] Assemble the panel magnet mounts (x10) |
|---|---|
| + | [* 2] panel_magnet_holder printed part |
| + | [* 3] Neodymium Disc Magnet - 10x4mm |
| + | [* 10] The magnets are designed to be a tight fit into the printed part. If they are loose, or you wish to secure them further, place a few drops of cyanoacrylate glue into the printed part before adding the magnet |
| + | [* 4] M6 Nylon Locking Hex Nut |
| + | [* 10] Set these assemblies aside until ***Step !!*** |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added