Changes to Step #5
Edit by Simon Davie —
Edit approved by Simon Davie
- Before
- After
- Unchanged
Step Lines
| [title] Assemble the panel magnet mounts (x10) | |
| [* 2] panel_magnet_holder printed part | |
| [* 3] Neodymium Disc Magnet - 10x4mm | |
| [* 10] The magnets are designed to be a tight fit into the printed part. If they are loose, or you wish to secure them further, place a few drops of cyanoacrylate glue into the printed part before adding the magnet | |
| [* 4] M6 Nylon Locking Hex Nut | |
| - | [* 10] Set these assemblies aside until *** |
| + | [* 10] Set these assemblies aside until ***Steps 7, 8 & 11*** |