Changes to Step #5
Edit by Simon Davie —
Edit approved by Simon Davie
- Before
- After
- Unchanged
Step Lines
| [title] Assemble the panel magnet mounts (x10) | |
| [* 2] panel_magnet_holder printed part | |
| [* 3] Neodymium Disc Magnet - 10x4mm | |
| + | [* 9] Pay attention to the orientation of the magnets when installing them into the printed parts. Use the assemblies from the previous step to verify the magnets attract to each other, rather than repell from each other! |
| [* 10] The magnets are designed to be a tight fit into the printed part. If they are loose, or you wish to secure them further, place a few drops of cyanoacrylate glue into the printed part before adding the magnet | |
| [* 4] M6 Nylon Locking Hex Nut | |
| [* 10] Set these assemblies aside until ***Steps 7, 8 & 11*** |