Changes to Step #8
Edit by Simon Davie —
Edit approved by Simon Davie
- Before
- After
- Unchanged
Step Lines
| [title] Assemble the door panel - Part 1 | |
| [* 10] There are 6 magnet mount positions on the door (or 4 on the 200). Repeat the following for each of them | |
| [* 2] panel_enc2_door_***''size''*** | |
| [* 3] M6x12 Cap Head Screw | |
| [* 4] M6 Washer | |
| [* 5] Panel magnet mount assembly from ***Step 5*** | |
| + | [* 9] Take care not to over tighten the M6x12 screw as you can damage the printed parts |