Changes to Step #9

Edit by Simon Davie —

Edit approved by Simon Davie

Before
After
Unchanged

Step Lines

[title] Assemble the door panel - Part 2
[* 10] There are 2 magnet mount positions on the door. Repeat the following for each of them
[* 2] panel_enc2_door_***''size''***
[* 3] Rat Rig nylon door handle
[* 4] M6x16 Cap Head Screw
[* 5] M6 Nylon Locking Hex Nut
-[* 10] Do not overly tighten the M6 nylon locking hex nuts when securing the handles, as this can cause the panel to warp which will prevent a good seal to the printer
+[* 9] Do not overly tighten the M6 nylon locking hex nuts when securing the handles, as this can cause the panel to warp which will prevent a good seal to the printer