Changes to Step #11
Edit by Simon Davie —
Edit approved by Simon Davie
- Before
- After
- Unchanged
Step Lines
| + | [title] Assemble the top panel |
|---|---|
| + | [* 2] panel_enc2_top_***''size''*** |
| + | [* 3] Install four of the panel magnet mount assemblies to the top panel |
| + | [* 9] Take care not to over tighten the M6x12 screw as you can damage the printed parts |
| + | [* 4] Install two of the Rat Rig nylon handles to the top panel |
| + | [* 10] Do not overly tighten the M6 nylon locking hex nuts when securing the handles, as this can cause the panel to warp which will prevent a good seal to the printer |
| + | [* 10] Set the completed top assembly aside until ***Step !!*** |
Image 1
No previous image
Added