Changes to Step #11

Edit by Simon Davie —

Edit approved by Simon Davie

Before
After
Unchanged

Step Lines

[title] Assemble the top panel
[* 2] panel_enc2_top_***''size''***
[* 3] Install four of the panel magnet mount assemblies to the top panel
[* 9] Take care not to over tighten the M6x12 screw as you can damage the printed parts
[* 4] Install two of the Rat Rig nylon handles to the top panel
- [* 10] Do not overly tighten the M6 nylon locking hex nuts when securing the handles, as this can cause the panel to warp which will prevent a good seal to the printer
+ [* 9] Do not overly tighten the M6 nylon locking hex nuts when securing the handles, as this can cause the panel to warp which will prevent a good seal to the printer
[* 10] Set the completed top assembly aside until ***Step !!***