Changes to Step #25
Edit by Simon Davie —
Edit approved by Simon Davie
- Before
- After
- Unchanged
Step Lines
| + | [title] Replace the rear right 3030 extrusion - Part 3 |
|---|---|
| + | [* 2] 760mm 3030 Extrusion |
| + | [* 3] Insert the 3030 extrusion into the bottom corner plate assemblies |
| + | [* 10] You may need to rotate the 3030 t-nuts to insert the 3030 extrusion |
| + | [* 4] Check the measurement shown. It should measure either 200mm (for a V-Core 3 200) or 250mm (for a V-Core 300, 400 or 500) |
| + | [* 9] Ensure the extrusion is fully inserted before continuting |
| + | [* 5] Tighten the six marked M6x12 screws to secure the 3030 extrusion to the frame |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added