Changes to Step #4
Edit by Simon Davie —
Edit approved by Simon Davie
- Before
- After
- Unchanged
Step Lines
| + | [title] Assemble the bowden clamp |
|---|---|
| + | [* 2] enclosure2_bowden_clamp Printed Part |
| + | [* 3] M6x12 Cap Head Screw |
| + | [* 10] Install the M6 cap head screw into the bowden clamp as shown |
| + | [* 4] 3030 Drop-in T-Nut - M6 |
| + | [* 10] Loosely thread a 3030 T-Nut onto the M6x12 screws. Do not tighten it at this point |
| + | [* 10] Set the bowden clamp assembly aside until ***Step 8*** |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added