Changes to Step #5
Edit by Simon Davie —
Edit approved by Simon Davie
- Before
- After
- Unchanged
Step Lines
+ | [title] Assemble the cable guide |
---|---|
+ | [* 2] electronics_wire_guide_rear Printed Part |
+ | [* 3] M6x12 Cap Head Screw |
+ | [* 10] Install the M6 cap head screw into the cable guide as shown |
+ | [* 4] 3030 Drop-in T-Nut - M6 |
+ | [* 10] Loosely thread a 3030 T-Nut onto the M6x12 screws. Do not tighten it at this point |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added