Changes to Step #7
Edit by Miguel Cruz —
Edit approved by Miguel Cruz
- Before
- After
- Unchanged
Step Lines
[title] Prepare the top and bottom of the frame - Part 2 | |
[* 2] Install one hidden three way corner assembly into the position shown. Tighten the M6x8 set screw to secure them. | |
[* 3] 500mm 3060 Extrusion | |
[* 9] Ensure the extrusions are flush and square with the hidden three way corner assembly before and after tightening the screws. | |
[* 4] Insert the rubber seals into the extrusion as shown, they should fully cover the length of the extrusion slot. | |
- | [* 10] Make sure all the seals are oriented in the same direction |
+ | [* 10] Make sure all the seals are oriented in the same direction. |