Changes to Step #8
Edit by Miguel Cruz —
Edit approved by Miguel Cruz
- Before
- After
- Unchanged
Step Lines
| + | [title] Prepare the top and bottom of the frame- Part 5 |
|---|---|
| + | [* 2] 500mm 3030 Extrusion |
| + | [* 3] 2x Hidden Three Way Corner Assembly |
| + | [* 10] Inser the hidden three way corner assembly into the 3030 extrusion fist, then place them on the previous assembly. |
| + | [* 5] Measure both of the distances shown using a long ruler (preferred), or a tape measure. The measurements should be equal to each other. |
| + | [* 9] If the measurements are not equal, and are not close to those shown above, double check all corners are square and then check again |
| + | [* 10] Go back to step 1 and build another assembly for the top of the V-Hive |
Image 1
No previous image
Added
Image 2
No previous image
Added