Changes to Step #8

Edit by Miguel Cruz —

Edit approved by Miguel Cruz

Before
After
Unchanged

Step Lines

-[title] Prepare the top and bottom of the frame- Part 5
+[title] Prepare the top and bottom of the frame- Part 4
[* 2] 500mm 3030 Extrusion
[* 3] 2x Hidden Three Way Corner Assembly
[* 10] Inser the hidden three way corner assembly into the 3030 extrusion fist, then place them on the previous assembly.
[* 5] Measure both of the distances shown using a long ruler (preferred), or a tape measure. The measurements should be equal to each other.
-[* 9] If the measurements are not equal, and are not close to those shown above, double check all corners are square and then check again
+[* 9] If the measurements are not equal, double check all corners are square and then check again
[* 10] Go back to step 1 and build another assembly for the top of the V-Hive