Changes to Step #8
Edit by Miguel Cruz —
Edit approved by Miguel Cruz
- Before
- After
- Unchanged
Step Lines
[title] Prepare the top and bottom of the frame - Part 4 | |
[* 2] 500mm 3030 Extrusion | |
[* 3] 2x Hidden Three Way Corner Assembly | |
[* 10] Inser the hidden three way corner assembly into the 3030 extrusion fist, then place them on the previous assembly. | |
[* 4] Insert the fourth rubber seal. | |
[* 5] Measure both of the distances shown using a long ruler (preferred), or a tape measure. The measurements should be equal to each other. | |
- | [* 9] If the measurements are not equal, double check all corners are square and then check again |
+ | [* 9] If the measurements are not equal, double check all corners are square and then check again. |
[* 10] Go back to step 1 and build another assembly for the top of the V-Hive Enclosure. | |
[* 11] Refer to ***Step 9*** for instructions on installing the seals. |