Skip to main content

Changes to Step #15

Edit by Miguel Cruz

Edit approved by Miguel Cruz

Before
After
Unchanged

Step Lines

[title] Front panel magnets
-[* 2] 2x Magnet Disk 10x4mm
+[* 2] 2x Neodymium Disc Magnet - 10x4mm
+[* 10] The magnets are designed to be a tight fit into the printed part. If they are loose, or you wish to secure them further, place a few drops of cyanoacrylate glue into the printed part before adding the magnet
[* 3] M6x12mm Cap Head Screw
[* 4] M6 T-nut 3030 Drop in
[* 5] V-Hive Magnet Holder
-[* 10] Don't tighten the screws.
+[* 10] Loosely thread the 3030 T-Nuts onto the M6x12 screws. Do not tighten them at this point.