Changes to Step #15
Edit by Miguel Cruz —
Edit approved by Miguel Cruz
- Before
- After
- Unchanged
Step Lines
| [title] Front panel magnets | |
| [* 2] 2x Neodymium Disc Magnet - 10x4mm | |
| [* 10] The magnets are designed to be a tight fit into the printed part. If they are loose, or you wish to secure them further, place a few drops of cyanoacrylate glue into the printed part before adding the magnet | |
| [* 3] M6x12mm Cap Head Screw | |
| [* 4] M6 T-nut 3030 Drop in | |
| - | [* 5] V-Hive Magnet Holder |
| + | [* 5] V-Hive Enclosure Magnet Holder |
| [* 10] Loosely thread the 3030 T-Nuts onto the M6x12 screws. Do not tighten them at this point. |