Changes to Step #15
Edit by Miguel Cruz —
Edit approved by Miguel Cruz
- Before
- After
- Unchanged
Step Lines
| - | [title] Front panel magnets |
|---|---|
| - | [* 2] |
| + | [title] Front panel magnets (x5) |
| + | [* 2] Neodymium Disc Magnet - 10x4mm |
| [* 10] The magnets are designed to be a tight fit into the printed part. If they are loose, or you wish to secure them further, place a few drops of cyanoacrylate glue into the printed part before adding the magnet. | |
| [* 3] M6x12mm Cap Head Screw | |
| [* 4] M6 T-nut 3030 Drop in | |
| [* 5] V-Hive Enclosure Magnet Holder | |
| [* 10] Loosely thread the 3030 T-Nuts onto the M6x12 screws. Do not tighten them at this point. |