Changes to Step #20
Edit by Miguel Cruz —
Edit approved by Miguel Cruz
- Before
- After
- Unchanged
Step Lines
| + | [title] Insert the Rubber Seals |
|---|---|
| + | [* 2] Only the top, bottom and side panels need rubber seals. |
| + | [* 3] Insert the rubber seals on the four sides, between the extrusion and the panel. They should fully cover the length of the extrusion slot. |
| + | [* 4] Make sure all the seals are oriented with the pointy tip to the panel. |
| + | [* 5] Push down with your finger until the rubber seal sits tight in the gap, ensuring a good isolation. |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added