Changes to Step #3

Edit by Miguel Cruz —

Edit approved by Miguel Cruz

Before
After
Unchanged

Step Lines

[title] Mount the Prusa mini
[* 10] Remove the printer's rubber feet before mounting it to the V-Hive Enclosure.
-[* 2] Make sure the rails are parallel with a distance of 157 mm.
+[* 2] Make sure the rails are parallel with a distance of 149.2 mm.
[* 3] Tighten the screws to the printer frame to ensure a stiff connection.
-[* 4] Center the printer on the enclosure by ensuring a distance of 143 mm.
+[* 4] Center the printer on the enclosure by ensuring a distance of 145.4 mm.
[* 5] Once all measurements are correct proceed to tighten the four M6x12 screws on the rails to the frame.