Changes to Step #3

Edit by Miguel Cruz —

Edit approved by Miguel Cruz

Before
After
Unchanged

Step Lines

[title] Mount the Prusa mini
[* 10] Remove the printer's rubber feet before mounting it to the V-Hive Enclosure.
[* 2] Make sure the rails are parallel with a distance of 149.2 mm.
-[* 3] Tighten the M6x15mm countersink screws to the printer frame to ensure a stiff connection.
+[* 3] Tighten the M6x14mm countersink screws to the printer frame to ensure a stiff connection.
[* 4] Center the printer on the enclosure by ensuring a distance of 145.4 mm.
-[* 5] Once all measurements are correct proceed to tighten the four M6x12 screws on the rails to the frame.
+[* 5] Once all measurements are correct proceed to tighten the three M6x14 screws on the rails to the frame.