Changes to Step #9
Edit by Miguel Cruz —
Edit approved by Miguel Cruz
- Before
- After
- Unchanged
Step Lines
| [title] Assemble the front idler plates | |
| [* 2] Rat Rig StrongHold CNC - Idler Plate | |
| [* 3] M8 Washer | |
| [* 4] M8x22 Cap Head Screw | |
| [* 5] 4040 Drop-in T-Nut - M8 | |
| [* 10] Repeat these instructions for the second idler plate. | |
| + | [* 11] Loosely thread a 4040 T-Nut onto each of the M8x25 screws. Do not tighten them at this point. |
| [* 10] Set these assemblies aside until Steps 11 & 12 |