Changes to Step #10

Edit by Miguel Cruz —

Edit approved by Miguel Cruz

Before
After
Unchanged

Step Lines

[title] Assemble the rear motor plates
-[* 2] Rat Rig StrongHold CNC - Motor Plate
+[* 2] Rat Rig StrongHold ONE CNC - Motor Plate
[* 3] M8 Washer
[* 4] M8x22 Cap Head Screw
[* 5] 4040 Drop-in T-Nut - M8
-[* 11] Loosely thread a 4040 T-Nut onto each of the M8x25 screws. Do not tighten them at this point.
+[* 11] Loosely thread a 4040 T-Nut onto each of the M8x22 screws. Do not tighten them at this point.
[* 10] Repeat these instructions for the second motor plate.
[* 10] Set these assemblies aside until Steps 16 & 17