Changes to Step #13

Edit by Miguel Cruz —

Edit approved by Miguel Cruz

Before
After
Unchanged

Step Lines

[title] Install the rear right motor plate
[* 2] Right motor plate assembly from Step 10
[* 3] Align the motor plate assembly with the base frame as shown
[* 4] M12 Washer
[* 5] M12x45 Cap Head Screw
-[* 10] Place an M12 washer on to each M12x45 cap head screw and loosely screw them through the plate and in to the extrusion
-[* 9] Do not fully tighten any of the M12 or M8 cap head screws at this point
+[* 10] Place an M12 Washer on to each M12x45 Cap Head screw and loosely screw them through the plate and in to the extrusion.
+[* 9] Do not fully tighten any of the M12 or M8 Cap Head Screws at this point