Changes to Step #14
Edit by Miguel Cruz —
Edit approved by Miguel Cruz
- Before
- After
- Unchanged
Step Lines
+ | [title] Install the rear left motor plate |
---|---|
+ | [* 2] Left motor plate assembly from Step 10 |
+ | [* 3] Align the motor plate assembly with the base frame as shown |
+ | [* 4] M12 Washer |
+ | [* 5] M12x45 Cap Head Screw |
+ | [* 10] Place an M12 washer on to each M12x45 cap head screw and loosely screw them through the plate and in to the extrusion |
+ | [* 9] Do not fully tighten any of the M12 or M8 cap head screws at this point |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added