Changes to Step #14
Edit by Miguel Cruz —
Edit approved by Miguel Cruz
- Before
- After
- Unchanged
Step Lines
[title] Install the rear left motor plate | |
[* 2] Left motor plate assembly from Step 10 | |
[* 3] Align the motor plate assembly with the base frame as shown | |
[* 4] M12 Washer | |
[* 5] M12x45 Cap Head Screw | |
- | [* 10] Place an M12 |
- | [* 9] Do not fully tighten any of the M12 or M8 |
+ | [* 10] Place an M12 Washer on to each M12x45 Cap Head screw and loosely screw them through the plate and in to the extrusion. |
+ | [* 9] Do not fully tighten any of the M12 or M8 Cap Head Screws at this point |