Skip to main content

Changes to Step #15

Edit by Miguel Cruz

Edit approved by Miguel Cruz

Before
After
Unchanged

Step Lines

+[title] Install the spoil board brackets
+[* 2] 4040 extruded corner assembly (For the spoilboard)
+[* 3] Position the 4040 extruded corner assembly in the middle of the extrusion gap as shown
+[* 4] The displayed measurement should be:
+ [* 10] MEASURE FUSION
+[* 5] Ensure that the top of the extruded corner assembly is flush with the top of the 4040 extrusions
+[* 6] Fully tighten the M8 cap head screw to secure the extruded corner assembly to the frame
+[* 7] Repeat the above instructions for the remaining 3 extruded corner assemblies

Image 1

No previous image

New image

Added

Image 2

No previous image

New image

Added

Image 3

No previous image

New image

Added