Changes to Step #15
Edit by Miguel Cruz —
Edit approved by Miguel Cruz
- Before
- After
- Unchanged
Step Lines
| [title] Install the spoil board brackets | |
| [* 2] 4040 extruded corner assembly (For the spoilboard) | |
| [* 3] Position the 4040 extruded corner assembly in the middle of the extrusion gap as shown | |
| [* 4] The displayed measurement should be: | |
| - | [* 10] MEASURE FUSION |
| - | [* 5] Ensure that the top of the extruded corner assembly is flush with the top of the 4040 extrusions |
| - | [* 6] Fully tighten the M8 cap head screw to secure the extruded corner assembly to the frame |
| + | [* 10] 202mm for StrongHold ONE 750x750 |
| + | [* 10] 327mm for StrongHold ONE 750x1250 |
| + | [* 10] 327mm for StrongHold ONE 1250x1250 |
| + | [* 5] Ensure that the top of the extruded corner assembly is flush with the top of the 4040 extrusions. Fully tighten the M8 cap head screw to secure the extruded corner assembly to the frame |
| [* 7] Repeat the above instructions for the remaining 3 extruded corner assemblies |