Skip to main content

Changes to Step #16

Edit by Miguel Cruz

Edit approved by Miguel Cruz

Before
After
Unchanged

Step Lines

[title] Ensure the base frame is square
[* 10] Before continuing with the assembly, the frame must be squared and all screws full tightened
-[* 1] Using an engineers square, check that the side 40120 extrusions are square to the extrusions forming the base
+[* 2] Using an engineers square, check that the side 40120 extrusions are square to the extrusions forming the base
[* 10] On each side, tighten all of the following screws whilst continuing to check that the side extrusion remain square with the base:
[* 3] 4x M8x16 within the cast corners connected to the base
[* 4] 6x M12x45 on the motor and idler plates
[* 5] 4x M8x22 on the motor and idler plates
[* 10] Once one side is fully secured and squared, proceed to repeat the process on the other side
[* 10] After tightening all screws, check the entire frame once more for squareness. Correcting any issues now is easier than once the assembly is complete!