Changes to Step #20

Edit by Miguel Cruz —

Edit approved by Miguel Cruz

Before
After
Unchanged

Step Lines

[title] Assemble the HG15 linear rails
[* 9] Do not allow the linear rail carriages to leave the end of the rail at any point
[* 2] HG15 Linear Rail
-[* 3] Insert an M4x20 cap head screw in to each of the holes on the linear rail
+[* 3] Insert an M4x20 cap head screw into each of the holes on the linear rail
[* 4] Loosely thread a 4040 T-Nut on to each of the M4x20 screws
[* 10] Repeat these instructions for the second linear rail