Skip to main content

Changes to Step #14

Edit by Miguel Cruz

Edit approved by Miguel Cruz

Before
After
Unchanged

Step Lines

+[title] Install the XZ joiner plate - Part 2
+[* 2] Push the XZ Plate to the right
+[* 3] Tighten the first M3x16 screw on the bottom rail
+[* 4] Push the XZ Plate to the left
+[* 5] Tighten the last M3x16 screw on the bottom rail
+[* 6] Tighten every other M3x16 screw, starting from one end
+[* 7] Tighten the remaining M3x16 screws, starting from the same end as before
+[* 9] If the X-axis binds or becomes tight, check that the lower rail is aligned correctly. Loosening the screws securing the lower rail to the 40120 extrusion and repeat the steps above.
+[* 11] Do not overtighten the screws as it can cause the axis to bind.

Image 1

No previous image

New image

Added

Image 2

No previous image

New image

Added

Image 3

No previous image

New image

Added