Skip to main content

Changes to Step #2

Edit by Miguel Cruz

Edit approved by Miguel Cruz

Before
After
Unchanged

Step Lines

+[title] Align the X-Gantry
+[* 2] Lossen the Y- rail carriage screws a little bit.
+[* 3] Adjust the belt tensioning screw in order to equal the gap on both sides.
+ [* 4] If you tighten the belt tensioning screw, the grantry will move foward, closing the gap.
+ [* 5] If you loosen the belt tensioning screw, the grantry will move back, enlarging the gap.
+[* 6] Adjust both belt tensioning screws until the gap is equal on both sides and the gantry sits flush on the front plates.

Image 1

No previous image

New image

Added

Image 2

No previous image

New image

Added

Image 3

No previous image

New image

Added