Changes to Step #2

Edit by Miguel Cruz —

Edit approved by Miguel Cruz

Before
After
Unchanged

Step Lines

[title] Align the X-Gantry
-[* 2] Lossen the Y- rail carriage screws a little bit.
+[* 2] Lossen the Y-rail carriage screws a little bit.
[* 3] Adjust the belt tensioning screw in order to equal the gap on both sides.
[* 4] If you loosen the belt tensioning screw, the grantry will move foward, closing the gap.
[* 5] If you tighten the belt tensioning screw, the grantry will move back, enlarging the gap.
[* 6] Adjust both belt tensioning screws until the gap is equal on both sides and the gantry sits flush on the front plates.
[* 10] Squeeze the XY-Joiner against the front plate to feel if there is any play. While squeezing there shouldn't be any play, keep adjusting the belt tensioning screws until there is no gap on either side.