Changes to Step #18

Edit by Simon Davie —

Edit approved by Simon Davie

Before
After
Unchanged

Step Lines

-[title] Assemble the BTT Rodent CNC controller & mount
+[title] Assemble the Rodent CNC controller & mount
[* 2] 2x Rodent mount assemblies
[* 3] 1x BIGTREETECH Rodent CNC controller
[* 4] 4x M3x6 cap head screw
-[* 10] Align the BTT Rodent CNC controller with the holes on the mounts. Secure the controller to the mounts using the M3x6 cap head screws
+[* 10] Align the Rodent CNC controller with the holes on the mounts. Secure the controller to the mounts using the M3x6 cap head screws
[* 9] Take care not to over-tighten the screws as you can damage the printed parts or the controller
[* 10] Set the controller assembly aside until [guide|296|Step 25|stepid=3252]