Changes to Step #20

Edit by Simon Davie —

Edit approved by Simon Davie

Before
After
Unchanged

Step Lines

[title] Assemble the enclosure - Part 1
[* 2] 1x compact_cnc_bottom_panel
[* 3] 4x Corner assembly
[* 4] 4x M3x6 countersunk screw
-[* 10] Align each corner assembly with the bottom panel, secure them together with an M3x6 countersunk screw
-[* 9] Take care not to over-tighten the screws as you can damage the printed parts or the controller
+[* 5] Align each corner assembly with the bottom panel, secure them together with an M3x6 countersunk screw
+[* 9] Take care not to over-tighten the screws as you can damage the printed parts