Changes to Step #4
Edit by Simon Davie —
Edit approved by Simon Davie
- Before
- After
- Unchanged
Step Lines
| [title] Install the stepper drivers - Part 1 | |
| [* 2] 1x Stepper driver - OMC DM542T | |
| [* 3] 2x M4x16 cap head screw | |
| [* 4] 2x M4 washer | |
| - | [* 10] Install an M4 washer on to each |
| + | [* 10] Install an M4 washer on to each M4x16 screw |
| [* 5] Align the stepper driver with the holes on the panel, and insert an M4x16 screw through the stepper driver and panel as shown | |
| [* 9] Keep supporting the stepper driver until the locking hex nuts are installed in the next step |