Changes to Step #5

Edit by Simon Davie —

Edit approved by Simon Davie

Before
After
Unchanged

Step Lines

[title] Install the stepper drivers - Part 2
[* 2] 2x M4 locking hex nut
-[* 3] Install an M4 locking hex nut on to each of the M4x16 cap head screws and tighten to secure the stepper driver to the panel
+[* 3] Install an M4 locking hex nut on to each of the M4x16 screws and tighten them to secure the stepper driver to the panel
[* 4] Repeat the previous step, and this step, to install the remaining 3 stepper drivers as shown