Changes to Step #7
Edit by Simon Davie —
Edit approved by Simon Davie
- Before
- After
- Unchanged
Step Lines
| [title] Assemble the bottom frame front & back (x2) | |
| [* 2] 1x 1102mm 3060 extrusion | |
| [* 3] 2x 3030 cast 90 degree corner assemblies | |
| [* 4] Install one corner assembly onto each end of the 1102mm 3060 extrusions as shown. Tighten the M6x12 screw to secure them. | |
| [* 9] Ensure the corner assemblies are flush and square with the ends of the extrusions after tightening the screws | |
| + | [* 10] Set these assemblies aside until [guide|301|Step 9|stepid=3322] |