Changes to Step #10
Edit by Simon Davie —
Edit approved by Simon Davie
- Before
- After
- Unchanged
Step Lines
| [title] Assemble the enclosure frame - Part 2 | |
| [* 2] 1x 850mm 3030 extrusion | |
| - | [* 3] Align the 850mm 3030 extrusion |
| + | [* 3] Align the 850mm 3030 extrusion into the corner of the bottom frame assemblies as shown, make sure it is square |
| [* 9] Make sure the end of the 850mm 3030 extrusion which has been tapped, faces downwards towards the bottom frame, otherwise you will be unable to install the feet in a later step | |
| [* 4] Tighten the marked M6x12 screws to secure the 850mm 3030 extrusion to the bottom frame | |
| [* 5] Repeat these instructions to install and secure the remaining 3x 850mm 3030 extrusions as shown |