Changes to Step #16

Edit by Simon Davie —

Edit approved by Simon Davie

Before
After
Unchanged

Step Lines

[title] Assemble the enclosure frame - Part 8
[* 2] 1x 1102mm 3060 extrusion
[* 3] Position the extrusion so the marked gap measures 140mm
[* 4] 4x 3030 cast 90 degree corner assembly
[* 5] Install a 3030 cast 90 degree corner assembly into each inner corner as shown
[* 10] Tighten both M6x12 screws on each corner assembly to secure the frame together
-[* 10] Double check the 140mm measurement once the 3030 cast 90 degree corner brackets are secured
+[* 10] Double check the 140mm measurement once the 3030 cast 90 degree corners are secured