Changes to Step #34
Edit by Simon Davie —
Edit approved by Simon Davie
- Before
- After
- Unchanged
Step Lines
| [title] Assemble the door magnetic latches (x4) | |
| [* 2] 1x V-Core 4 frame magnet holder - nylon | |
| [* 3] 2x Magnet - Neodymium disc - 10x4mm | |
| [* 9] It is important to make sure the polarity of the magnets are correct. Use the assemblies from [guide|301|Step 27|stepid=3341] to make sure the magnets do not repel each other | |
| [* 11] ***Tip:*** Use a drop of super glue to prevent the magnets from coming loose over time | |
| [* 4] 1x M6x12 cap head screw | |
| [* 5] 1x T-nut drop-in for 3030 - M6 | |
| [* 10] Loosely thread the 3030 T-nut onto the M6x12 screw. Do not tighten it at this point | |
| + | [* 10] Set these assemblies aside until [guide|301|Step 36|stepid=3350] and [guide|301|Step 38|stepid=3352] |