Changes to Step #49
Edit by Simon Davie —
Edit approved by Simon Davie
- Before
- After
- Unchanged
Step Lines
| [title] Assemble the door panel (x2) - Part 1 | |
| [* 2] 1x panel_enclosure_mill_door panel | |
| [* 3] For each of the 13x marked holes, install the mounting hardware as shown in [guide|301|Step 22|stepid=3336] | |
| + | [* 10] Loosely thread the 3030 T-nuts onto the M5x12 screws. Do not tighten them at this point |
| [* 10] The door panels are identical for left and right, assemble both the same |