Changes to Step #4
Edit by Paweł Kucmus —
Edit approved by Paweł Kucmus
- Before
- After
- Unchanged
Step Lines
| [title] Attach the Z rails | |
| [* 10] Do not bolt down all of the screws yet, just secure the rail by the two screws on the ends - later adjustment maybe required | |
| [* 1] Attach the 3x 400mm Z rails into the frame | |
| - | [* 2] Measure the space between the side of the rail and the side of the extrusion - for 3030 it should be 9.00mm on each side - measure in 4 points |
| + | [* 2] Measure the space between the side of the rail and the side of the extrusion - for 3030 it should be 9.00mm on each side - measure each rail in 4 points |