Skip to main content

Changes to Step #10

Edit by Rat Rig

Edit approved by Rat Rig

Before
After
Unchanged

Step Lines

+[* black] Pick up the tip of the ***Belt*** on the opposite side and slide it behind the other ***T-Nut***, which should be placed near the end of the rail. Pull from the opposite side until the belt is snug against the rail.
+[* black] Screw the remaining ***Knob*** on the ***T-Nut***. Right before it locks in place, the knob will start biting the belt. When this happens, you can fine-tune the tension on the belt by moving the ***T-Nut ***slightly to the left or right.
+[* black] Finish screwing the Knob to lock the*** T-Nu***t in place.
+[* black] Cut off the remaining length of the ***Belt***. You’re done!