Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect the guide that includes this step.

Step Type:

Drag to rearrange

enc_3030_spool_holder_guide printed part

M5x12 Cap Head Screw

3030 Drop In T-Nut M5

Loosely thread the 3030 T-Nuts onto the M5x12 screws. Do not tighten them at this point.

Install the spool holder guide assembly onto the rear 3030 extrusion of the lid as shown. Make sure that the M5 T-Nuts drop into the 3030 extrusion slot.

Gently tighten the two M5x12 cap head screws

Do not over tighten these screws as doing so could cause damage to the printed part.

Your contributions are licensed under the open source Creative Commons license.