Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect the guide that includes this step.

Step Type:

Drag to rearrange

3030_end_cap

Install the 3030 extrusion end cap by carefully pushing it into place

M5x10 Cap Head Screw

3030 Drop-in T-Nut M5

Install the printed assembly onto the arm of the spool holder, making sure that the M5 T-Nuts drop into the 3030 extrusion slot

Gently tighten the two M5x10 cap head screws

Do not over tighten these screws as doing so could cause damage to the printed part

Your contributions are licensed under the open source Creative Commons license.