Editing Step 6 —
Final Assembly

Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect the guide that includes this step.

Step Type:

Drag to rearrange

Install the printed assembly onto the arm of the spool holder, making sure that the M5 T-Nuts drop into the 3030 extrusion slot.

Gently tighten the two M5x10 cap head screws using a 4mm hex key.

Do not over tighten these screws as doing so could cause damage to the printed part.

Install the 3030 extrusion end caps by carefully pushing them into place.

Your contributions are licensed under the open source Creative Commons license.